BST / LC Double Suction Split Casing Pump

BST / LC Double Suction Split Casing Pump

Overview

BST and LC are single stage double suction pumps with a horizontally split casing. Water enters the impeller from both sides, which balances axial thrust and allows large flows to be handled at moderate head with stable operation. The upper half of the casing lifts off for inspection, so the rotor can be checked without breaking the suction and discharge connections.

Construction

The volute casing is split along the shaft centre line, with the suction and discharge flanges cast into the lower half. A double entry impeller runs between two bearing housings, with shaft sealing by mechanical seal or packed gland on each side. The pump is coupled to a motor on a common base frame; bearing and seal materials are selected with the liquid and the duty.

Model Designation

BST and LC are followed by the suction and discharge diameters and the impeller diameter for the selected build. The impeller trim fixes the duty point, so the same casing can cover several flow and head combinations. The performance curve and the section drawing of the exact build are issued with the quotation.

Technical Data

Rated flow, head, efficiency, motor power and flange sizes are fixed per model and must be checked against the system curve. Standard flange drilling follows GB with DIN or ANSI available on request. We supply the curve, general arrangement drawing, shaft seal arrangement and motor schedule for approval before manufacture.

Application

Municipal water intake and distribution, power plant cooling water, irrigation and drainage stations, industrial circulating water, and large building HVAC systems with high continuous flow.

Note

Advise flow, head, liquid and temperature, available NPSH, pipe sizes and supply voltage and frequency. We will confirm the impeller trim, motor rating, curve and foundation drawing.