PMP Close Coupled Self Priming Pump
Overview
PMP is a close coupled self priming centrifugal pump with the impeller on the extended motor shaft, so no coupling or base alignment is needed. Once filled, the built in air separation chamber re-primes the suction line at each start. The unit sits above the water source with the motor dry and accessible.
Construction
A single stage volute casing carries a priming chamber that retains liquid between starts. A closed impeller runs on the extended motor shaft, with a mechanical seal at the shaft passage. The motor flange bolts to the casing, suction and discharge flanges are cast in, and wetted materials follow the liquid.
Model Designation
PMP is followed by the suction and discharge sizes and the motor rating. Flow, head and suction lift fix the impeller and motor, so one code covers several duty points. The curve, priming arrangement and outline drawing of the chosen build are issued with the quotation.
Technical Data
Rated flow, head, priming height, motor power and speed are fixed per model. Achievable suction lift depends on liquid temperature, altitude and pipe length, so it is confirmed for the site. Motors match the site voltage and frequency; flanges follow GB drilling. We confirm the curve and drawing before order.
Application
Water transfer from wells, ponds, rivers and tanks, irrigation, construction dewatering, small municipal and industrial supply, and any duty where the pump is mounted above the source and repeated manual priming is impractical.
Note
Please advise flow, head, liquid, temperature, suction lift, pipe length and diameter, altitude, and the site voltage and frequency. We will confirm the build, motor rating, priming arrangement, curve and foundation drawing.
