MS Split Casing Pump

MS Split Casing Pump

Overview

MS is a horizontal axially split, double-suction centrifugal pump for high flow duties. The casing splits along the shaft centre line, so the upper half lifts off for inspection of the impeller, bearings and seals without removing the pump from the pipework or disturbing the suction and discharge mains.

Construction

A double-suction impeller is mounted between two bearings, which hydraulically balances axial thrust and gives a low NPSH requirement. Suction and discharge nozzles are cast into the lower half of the casing in a horizontal plane. The shaft is supported by grease or oil lubricated bearings at both ends, with packed gland or mechanical seal at each shaft passage.

Model Designation

MS is followed by the nominal suction and discharge diameters and the impeller diameter or nominal head. The exact build is selected from the system curve before quotation.

Technical Data

Flow, head, speed, motor power and NPSH requirement are fixed per model and must be matched to the installation. We issue the performance curve, outline and foundation drawing, and shaft seal arrangement of the selected model with the quotation.

Application

Municipal waterworks and raw water intake, large-scale irrigation and drainage pumping stations, power plant circulating water, industrial cooling water systems, dock and flood control pumping, and large building HVAC water loops.

Note

Please advise flow, head, suction lift, liquid, voltage and frequency when enquiring. We will confirm the model, curve, NPSH and foundation drawing accordingly.