XST End Suction Centrifugal Pump

XST End Suction Centrifugal Pump

Overview

XST is a horizontal single stage end suction pump for clear water and light industrial liquid transfer. Liquid enters axially and leaves through a radial top discharge. Its back pull out construction lets the whole rotating assembly withdraw from the rear while the casing stays connected to the pipework.

Construction

A volute casing with axial suction and top discharge bolts to a rear cover carrying the bearing housing and seal. A closed impeller runs on a shaft with grease or oil lubricated bearings, sealed by a mechanical seal or packed gland. The pump is coupled to a motor on a fabricated base with a guarded flexible coupling.

Model Designation

XST is followed by the suction and discharge sizes and the impeller diameter or motor rating. Flow and head fix the impeller trim and motor, so the code does not define a single duty point. The curve, dimension drawing and motor schedule are supplied with the quotation.

Technical Data

Rated flow, head, speed, motor power, required NPSH and flange sizes are fixed per model and checked against the duty point. Motors match the site voltage and frequency, and flanges follow GB drilling with DIN or ANSI drilling available. We confirm the impeller trim, curve and base drawing before manufacture.

Application

General water supply and booster sets, irrigation, heating and cooling water circulation, HVAC systems, industrial process water, and transfer of clean or slightly contaminated liquids in buildings and plants.

Note

Advise flow and head, liquid, temperature, suction conditions and available NPSH, pipe sizes, and the site voltage and frequency. We will confirm the model, impeller trim, curve and foundation drawing.