SP ST T U Self Priming Non Clogging Sewage Pump

SP ST T U Self Priming Non Clogging Sewage Pump

Overview

SP, ST, T and U are self priming non clogging sewage pumps that stay above the liquid rather than being lowered into a pit. The casing retains liquid to re-prime the suction line, while wide passages let solids and fibres pass without wrapping the impeller. They suit temporary drainage and permanent effluent duties.

Construction

The volute casing carries a priming chamber with a suction check valve and a hinged cleanout cover, so blockages clear without dismantling pipework. A semi open impeller runs on a heavy shaft in a grease lubricated bearing housing, with a mechanical seal in a separate chamber. The pump is coupled to a motor on a common base.

Model Designation

The series letter identifies the frame and hydraulic design, followed by inlet and outlet sizes and the motor rating. Flow, head and the solids to be handled fix the final build. The curve, maximum solids passage and dimension drawing are issued with the quotation.

Technical Data

Rated flow, head, priming lift, allowable solids size, motor power and speed are fixed per model. Solids concentration, temperature and suction lift influence the achievable duty and are checked for the site. Motors match the site voltage and frequency, and we provide the curve, material schedule and outline drawing for approval.

Application

Municipal and building wastewater, septic and industrial effluent containing grit or fibres, flood and storm drainage, construction dewatering, sump emptying, and emergency drainage where a surface mounted pump is preferred.

Note

Send flow and head, solids size and concentration, liquid and temperature, suction lift and pipe layout, and the site voltage and frequency. We will confirm the series, impeller type, materials, curve and base drawing.