EA End Suction Centrifugal Pump
Overview
The EA is a horizontal single stage end suction pump used for general water supply and circulation. Its back pull out construction means the bearing housing, shaft and impeller can be withdrawn from the rear while the casing stays connected to the suction and discharge pipes. That reduces maintenance time on installed sets and keeps alignment work to a minimum.
Construction
A volute casing carries an axial suction port and a radial discharge flange. The impeller is mounted on a shaft supported by a bearing housing, with a mechanical seal or packed gland at the shaft passage. The pump is close coupled or flexible coupled to a standard motor on a common base frame; casing and impeller materials follow the liquid being handled.
Model Designation
EA is followed by the suction and discharge diameters and the impeller diameter selected for the duty. The impeller trim fixes the flow and head point, so the designation alone does not define performance. The curve and dimension drawing of the chosen build are supplied with the quotation.
Technical Data
Rated flow, head, motor power, speed and connection sizes are fixed per model. Flange drilling follows GB as standard with other standards available, and motors are matched to the site voltage and frequency. We issue the performance curve, general arrangement drawing and motor schedule for approval before order.
Application
Building and municipal water supply, HVAC circulation, boiler feed and condensate handling, irrigation, washing systems and general industrial clean water transfer.
Note
Send the duty flow and head, liquid and temperature, suction conditions, pipe sizes and supply voltage and frequency. We will confirm the impeller trim, motor rating, curve and foundation drawing.
