2BV Liquid Ring Vacuum Pump
Overview
2BV is a single-stage liquid ring vacuum pump. An eccentrically mounted impeller throws the service liquid outwards to form a rotating ring inside the casing; the changing volume between the impeller vanes and the ring draws in and compresses gas. The result is a near-isothermal compression that tolerates wet gas, vapour and small amounts of entrained liquid.
Construction
The pump is close-coupled or baseplate mounted with a standard motor, and the casing and impeller are supplied in cast iron or stainless steel depending on the gas and service liquid. The service liquid can be run once-through, partially recirculated, or fully recirculated through a separator and heat exchanger. Connections are sized for the suction and discharge gas load.
Model Designation
2BV is followed by the nominal pumping speed or impeller size. The required size follows the gas load, suction pressure and service liquid temperature, and is confirmed before quotation.
Technical Data
Pumping speed, ultimate vacuum, motor power, service liquid flow and allowable gas temperature are fixed per model and depend on the service liquid temperature and the gas composition. We issue the performance curve, outline drawing and utility requirements of the selected model with the quotation.
Application
Vacuum evaporation and crystallisation, vacuum filtration and dewatering, degassing and deaeration, vacuum drying, condenser air extraction, vacuum packaging, pulp and paper suction rolls, and chemical process vacuum systems.
Note
Please advise the gas composition, required suction pressure, pumping speed or volume to be evacuated, service liquid and its temperature, voltage and frequency when enquiring. We will confirm the model, curve and separator arrangement accordingly.
